‫Now, since we are losing the article SDR as the receiver SDR, so we will choose the OR smoke source
‫for it in the Jeonju radio.
‫And there is also an article, SDR source for the Jeonju radio.
‫But since that source and the small claims source, they both work fine for the article SDR.
‫So we are using these or smoke source and we are calling it a source because this blog would be used
‫to receive these R.F. Signa using the Ardian SDR.
‫So we are calling it as the source and then we need to set the parameters of this blog.
‫We have said these synchronization who don't sing just as at the transmitter.
‫We have said the sampling rate to 256 K.
‫This is the rate at which the SDR gives the iron dequeue simples to the Jeonju radio.
‫And since that the transmitter, we had the same rate.
‫So at the receiver we are also setting the same rate.
‫And then the central frequency of the getthere that is being received here.
‫We have set it to the 42 megahertz.
‫And then when a signal is received by the RTL SDR, it is amplified by NDB.
‫After that, when the signal passes through the IVF stage.
‫It is again amplified by these 20.
‫And when the signal is demodulator to the basement, it is again mortify.
‫It is again amplified by grunty D.V..
‫And this is the baseband game.
‫So this is how we set the parameters of the article SDR.
‫And Fiorentino.
‫We don't or anything because there is only one antenna in the article SDR.
‫And it is only used for receiving.
‫So it is quite a scoop.
‫Now how do we connect this or smoke one source in the Jeonju radio?
‫Now earlier we said that we have removed the channel more than sort and the output of the channel model
‫was connected to the early phase glogg synchronization block in the previous Antoin transmission simulation
‫floor, like Grupp.
‫All right, and we have removed the channel model, so then we will connect the auth moguls with Oprah.
‫That will leave his clock synchronization in port.
‫This means that now, instead of taking the input from the general model blog, the Polyphemus clock
‫synchronization block would be taking the input from the smoke comm source, which would be receiving
‫the actual Real-Time RF signal using the article SDL.